CHAR-LYNN (EATON) 104-1391-006
CHAR-LYNN (EATON)
CHAR-LYNN (EATON) 104-1391-006
104-1391-006 PART NUMBER
Hydraulic Geroler Disc Valve Motor - 2000 - Standard, 393.8 cm³/r Max Geometric Displacement, 2250 psi Maximum Operating Pressure
QTY QUOTE
SPECIFICATIONS
| Series | 2000 - Standard |
|---|---|
| Replacement Balance Ring - Sold Separately | 006 Design - 8915-000 - 1 Required |
| Displacement | 24.03 in³/r |
| Replacement Buna Seal Kit - Sold Separately | 006 Design - 61258-000 - 1 Required |
| Maximum Operating Pressure | 2250 psi |
| Replacement Drive - Sold Separately | 006 Design - 21371-008 - 1 Required |
| Continuous Torque | 6859 in-lbs |
| Replacement Drive Valve - Sold Separately | 006 Design - 8433-000 - 1 Required |
| Maximum Rpm | 191 rpm |
| Replacement Geroler - Sold Separately | 006 Design - 21625-008 - 1 Required |
| Mounting Type | 4-Bolt Flange - 3.25 in Pilot |
| Replacement Housing, Bearing Side (Front) - Sold Separately | 006 Design - 21578-005 - 1 Required |
| Motor Port Type | Straight Thread O-Ring SAE |
| Replacement Long Cap Screw (Cap End) - Sold Seprately | 006 Design - 14384-014 - 4 Required |
| Motor Port Size | 7/8?14 UNF-2B |
| Replacement Output Shaft And Bearing Kit - Sold Separately | 006 Design - 21618-023 - 1 Required |
| Shaft Type | Keyed |
| Replacement Pin For Balance Ring - Sold Separately | 006 Design - 14351-000 - 2 Required |
| Maximum Flow Rate | 20 gpm |
| Replacement Plate Valve - Sold Separately | 006 Design - 22134-000 - 1 Required |
| Maximum Operating Temperature | 180 °F |
| Replacement Rear Housing - Sold Separately | 006 Design - 21564-007 - 1 Required |
| Output Shaft Size | 32 mm Straight - Straight Key |
| Replacement Valve-Sold Separately | 006 Design - 21466-000 - 1 Required |
| Seal Type | Single Lip Seal |
| Replacement Viton Seal Kit - Sold Separately | 006 Design - 61263-000 - 1 Required |
| Operation Mode | Continuous Rating - Motor May Be Run Continuously At These Ratings. / Intermittent Operation - 10 Percent Of Every / Peak Operation - 1 Percent Of Every Minute |
| Replacement Wear Place - Sold Separately | 006 Design - 22102-000 - 1 Required |
| Drain Connection Size | G 1/4 British Standard Pipe |
| Replacement Pin For Balancing Ring - Sold Separately | 006 Design - 14351-000 - 2 Required |
| Operation Rating Description | Continuous Rating - Motor May Be Run Continuously At These Ratings. / Intermittent Operation - 10 Percent Of Every / Peak Operation - 1 Percent Of Every Minute |
| Actual Mounting Flange | 4-Bolt Flange - Non Sae Rated - With 3-1/4 In. Pilot Dia. |
| Port Orientation | Staggered Ports |
